Installation Instructions

Tips for Installation

Thoroughly clean surface area where product will be applied.
Test fit material while the backing is still on. If necessary trim material for optimal fit.
Remove backing on material. Use a spray bottle to spray mist of water directly to adhesive side of material. It is not necessary to add any soap or other product to water.
Keep fingers wet during entire application.
Remove backing from material and align to area being applied.
Start at one end of the material and using your fingers slowly press against the surface. Apply from top to bottom pressing only against the middle of the material. After the middle is secure begin moving closer to the edges. Keep the surface wet and use fingers or credit card to remove any small bubbles or water marks. To a certain extent the product may be removed and realigned while the surface is still wet.
It may take up to 2 full days for any bubbles or water marks that cannot be removed by hand to completely dry. Check periodically during the first few hours after install to make sure all edges and corners are still applied.
Once product is secure and no water is present, it is not designed to be removed and reapplied. If removal is necessary, begin at one end and slowly stretch product up at an angle to remove. Do not pull product back over itself while trying to remove.

NOTE - If product is installed poorly, over a dirty surface, or over excessively sharp curves, the adhesive backing may fail and product will begin to peel back. Trimming may be necessary for optimal fit and finish when excessive curves are involved.